To get the most out of your outerwear, keep it clean. The following information describes some basic cleaning procedures. But always read and follow the care instructions sewn into any garment before you wash it.
It's easy to wash your outerwear:
Machine wash in warm water with liquid detergent.
Tumble dry on medium heat.
Baixing Group. currently does not recommend the use of powdered soaps or any soaps containing fabric softeners, conditioners, stain removers or bleach when washing outerwear.
Use the exact same liquid detergent you plan to use to wash your outerwear (see above for details on what kind of detergent to use). Rub some of that detergent into the stained area and run the garment through a prewash cycle prior to laundering it. If your machine has no prewash cycle, then rub in the detergent and presoak the garment instead.
Like virtually all rainwear, outerwear comes with a DWR (durable water repellent) treatment on its outer surface. DWR causes water to bead up and roll off the garment. This clears the fabric surface so that sweat and body heat can pass through from the inside. It also keeps the fabric surface drier, which makes your outerwear light and comfortable.
Eventually, with regular laundering and exposure to the elements, DWR treatments can wear off. When this occurs, water no longer beads on the surface of the fabric, and the fabric may absorb some water. (The barrier beneath the outer fabric, however, will still stop this moisture from getting to your skin.)
The best way to renew your DWR is to launder your outerwear according to the care instructions and iron it using a warm steam setting. This will restore the water beading on the outer surface of the fabric as long as the original water-repellent treatment is present.
There is no such thing as permanent water-repellent treatment. Over time, the original repellent finish will be depleted and you'll need to use a spray-on or wash-in water-repellency treatment to treat the fabric. You may repeat this process as many times as needed.
A Case of Mistaken Identity
Performance problems caused by worn DWR coatings are often mistaken for fabric failures. This is due to the fact that when DWR coatings wear off, layers may:
Appear wet on the outside—since the outer fabric may absorb some water.
Feel heavier—again, due to water absorption.
Collect condensation on the inside—water on the fabric's surface can lower the temperature of the fabric through evaporative heat loss. This can cause warm, humid air inside the garment to condense on the inside surface so it feels wet—like it's leaking.
Before you consider replacing your jacket or rain pants, first try restoring your DWR or reapplying a spray-on or wash-in coating. Remember—just because the outer fabric becomes wet does not mean that water is passing through the membrane layer laminated to the inside of your garment.
Machine wash in cold water with a mild powder detergent. Baixing recommends using a front-loading washer.
Tumble dry, on low heat.
Touch up with a warm (not hot) iron.
Baixing Fabric and Salt Water
Salt water does not contaminate, clog the pores, decrease the breathability, alter or harm fabric. So you can sail, paddle and cruise with confidence.
Salt is a desiccant, meaning it attracts moisture. To keep salt from accumulating on your outerwear and attracting water, simply rinse it occasionally in fresh water. If you have limited fresh water supplies, even a rinse in sea water will reduce heavy salt accumulations (sea water is approximately 3% salt).